Some landscape designs call for a deck to join with a cinder block wall at a property line, a building or a planter. The deck-to-block connection is done with a ledger board attached to the block
Step-by-step instructions on how to install a deck ledger board to a concrete house foundation wall using expansion anchors. or wherever necessary. Always consult your local building inspector before attempting to attach a ledger board to a masonry wall. My local inspector says there is no code to install a ledger board to a concrete
How to Attach a Deck Ledger to a Poured Concrete Wall Garden Guides. Often the most difficult part of building a deck is attaching the deck to the house.
Using composite decking on a concrete foundation requires a frame for attachment. You can create this frame using a series of treated wood 2-by-4s. Securely attached to the slab, the frame creates a stable platform for the deck that's easier to nail into than the concrete itself and flexes along with the concrete, keeping the composite decking
Most homes have a poured concrete foundation making it tricky to attach the ledger board. Attaching it to a poured concrete wall is not i am building pt deck attached my house and have question
Re: Best way to attach a deck Ledger board to a block foundation What about attaching it to the wood structure of the cottage? You will likely at least have 2x8 floor joists so you should have approx. 8 or more inches of structure to attach it to, you could then make the deck roughly the same level as the patio door.
Often the most difficult part of building a deck is attaching the deck to the house. Most homes have a poured concrete foundation making it tricky to attach the ledger board.
Fastening a Ledger to Concrete: The ledger is not only the structural connection between the deck and the house; its also what establishes the overall height and levelness of the entire deck frame. On this project, the 2×10 joists of the main deck frame sit just about even with the top of the foundation, and a landing framed with 2x8s sits atop the main frame, serving as a transition point
Yes, there are products available for anchoring a ledger board to hollow concrete block foundations concrete masonry unit, CMU . There are a handful of manufacturers that produce epoxy and other adhesive anchors that are tested for use in hollow CMU.
Personally, I would and have done it this way drill all the way through the concrete foundation and run long bolts, or threaded rod, bolting your
This is the foundation of the deck and if not properly installed will result in failure of part or the entire deck. Unlike a concrete footing that distributes the weight of the structure over a large area, piers concentrate the load to a small area.
Installing Deck Ledgers. To attach a ledger against a wall through brick veneer: Mark anchor locations on your ledger and drill through the board with a ½ bit; the ledger board must be supported from beneath with a ledger attached to the solid concrete foundation at the bottom of the wall.
I have to attach a ledger board to a concrete wall with no access to the inside of the wall. Deck will be 10x16. Ledger board will have joist hangers attached and support the 10 foot joists They work great and i've used them for ledgers into foundation on low level decks, but i've not seen any specs. for something overhead etc.